Hand Tools

Float height gauge for dellorto VHSH and VHSB carbs Measures from 1.5mm to 5mm in .5mm increments…

Tool to help install the spring on the power valve for a Vortex Rok GP.

Removes belt driver of KA100 Recommend using starter ring gear lock for ease of use, sold separatel…

Holds ring gear in place to remove L.H. nut, or drive pullys Works on KA100, X30 and ROK GP Made b…

Fits all 2-stroke con rods w/ pistons Made from PET so as not to damage piston on contact used to …

Removes and installs all 14mm wrist pins

Used for honing a TAG cylinder Simulates pressure of head and crankcase Made from aluminum and mac…

Used for honing a Yamaha cylinder Simulates pressure of 4 cylinder nuts when honing Made from alum…

Precision machined and surface ground to exacting sizes: .035, .045, and .055 steps Laser etched wi…

Used for honing a Yamaha cylinder Simulates pressure of 6 head nuts when honing Made from aluminum…

Used to hold the needles in place while taking off the piston from the rod Made from steel with a h…

Remove and install C-51 wrist pin Padded anvil designed to not damage the piston Comes with a "dum…

Used for checking pop-off pressure above 15 psi and up to 30 psi Maximum 30 psi Comes complet…

Used for checking pop-off pressure up to 15 psi Maximum 15 psi Comes complete with everything to c…

Counts & Records cumulative operating time. Just wind antenna lead around spark plug wire. Vib…

Honda

Used to lap ring Made from quality steel

Screws into spark plug hole Completely adjustable Nylon tip so as not to damage piston 14mm threa…

.015 thick Used set Yamaha coil/rotor air gap .015 x 3/4" x 5 Non-magnetic material Sold 2 …

Fits most 1" and 2" dial indicators. Made from quality steel. Supplied with thumb screw.

.020 thick Used to set Yamaha coil/rotor air gap .020 x 3/4" x 5 Non-magnetic material Sold 2 pe…