Hand Tools

Float height gauge for dellorto VHSH and VHSB carbs Measures from 1.5mm to 5mm in .5mm increments…

Tool to help install the spring on the power valve for a Vortex Rok GP.

Removes belt driver of KA100 Recommend using starter ring gear lock for ease of use, sold separatel…

Holds ring gear in place to remove L.H. nut, or drive pullys Works on KA100, X30 and ROK GP Made b…

Fits all 2-stroke con rods w/ pistons Made from PET so as not to damage piston on contact used to …

Precision machined and surface ground to exacting sizes: .035, .045, and .055 steps Laser etched wi…

Used to hold the needles in place while taking off the piston from the rod Made from steel with a h…

Screws into spark plug hole Completely adjustable Nylon tip so as not to damage piston 14mm threa…

.015 thick Used set Yamaha coil/rotor air gap .015 x 3/4" x 5 Non-magnetic material Sold 2 …

Fits most 1" and 2" dial indicators. Made from quality steel. Supplied with thumb screw.

.020 thick Used to set Yamaha coil/rotor air gap .020 x 3/4" x 5 Non-magnetic material Sold 2 pe…

Used to hold new style rotors to remove nut Made from steel All hardware icluded

Used to remove ignition rotor on a Yamaha Made from steel All hardware included

Equipped with holes for jets Marked 54, 55, 56, 57, 58 Jets not supplied

Rethread or chase crank end on a Yamaha, Komet, TKM, etc. 7/8" O.D. adjustable Made fromn high spe…

Retap clutch nuts to remove residue Made from high speed steel

Rethread or chase crank end on a Yamaha, Komet, TKM, etc. 1 1/2" O.D. adjustable Made from high sp…

Rethread or chase spark plug holes in head Made from high speed steel